AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Have you all purchased the full programme with all the relevant passwords or codes and if so how. Without the particular code I could only run a highly reduced version of techstream which was pretty poor to be honest. Purely out of interest as I have downloaded Techstream in the past and had it running on my laptop with Windows 10.Īlways though it asks for a specific official code that you have to enter to demonstrate that it's a legitimate fully purchased copy and that you are a proper garage etc. Sorry I can't be more helpful, but I can only go by my setup. My car does not support all modules being a TR, if you click on a module not supported, you are notified. When I launch into Techstream, I do the usual -connect mini VCI cable to OBD socket, ignition on, confirm the make of the car, a menu option comes up with ' -11, 11-15, 15-', I choose '-11' and then on the next menu 'w/out smart key'. I tried removing the the codes using the Launch, jumper link via the OBD and Delphi. I use my standalone Launch scanner to calibrate the EPB, but it did a reset and remove the zeropoint calibrations for clutch and g-force. I was forced to use Techstream earlier this year, when I had a problem with EPB. I have other diagnostic software loaded, and they work using another USB adapter. The only thing that let's the Netbook down is the screen resolution is a little low, but works fine most of the time. I have to admit that I don't remember how I got everything working, but I am using an old Netbook with Windows XP.
0 Comments
Read More
Leave a Reply. |